Cleaning gun powder coatings can maintain and extend the useful life of equipment. The powder residue tends to stick in moist or humid climates gun, electrostatic powder painting reducing the effective performance. The powder coating is a dry material, and the residue left in the gun can be easily cleaned.

1 to prepare a powder spray gun, the cleaning area. Lay a tarp under the gun to flee, so that the powder residue will not spread and stained.

Gun powder coatings. Discharge gun voltage remaining.  wagner parts touch launch to the ground clip to fulfill the gun.

3 Loosen the cap cavity cup holders powder; pour the remaining powder in the powder container. The discharge of compressed air spray clean the outside of the pickup tube, deflector plates, cups and static tubes. Use no more than 30 pounds of compressed air.

4 wring diversion, and remove the three static tube. Cleaning the tube inside and outside - the diversion - with the air compressor. The air compressor is usually cleaning the pollen tube, but you can also use an engine cleaning brush.

5, Nordson spare parts spray the air in the tube, clean the pickup tube. Re-install the deflector and the static tube. Stored in a dry place, moisture-proof powder coating gun.